What this is
A set of rolling shop tables that park around the X1 stand. The X1 stays put and does the cutting. These tables roll in, snap together with magnets, then latch, and make a bigger work surface — or hold the first saw.
Three pieces in this first set: Flat (plain table), Extension (lighter helper), and Miter (DWS716XPS) (the DeWalt saw station). Every table is the same 36×36 inch outer size, so any side can join any side.
This page is a draft so you can see the program is real. Amber on purpose — not the X1 stand, not the insect flyer.
The three tables
Flat
Plain top, a shelf underneath, wheels that lock. The default island table.
/workbench/flat/
Extension
Same size and snap-together faces. Lighter. Grows a bigger top or infeed/outfeed.
/workbench/extension/
Miter (DWS716XPS)
Pocket for a DeWalt DWS716XPS. Removable inserts so a later saw can swap in.
/workbench/miter/Locked sizes
| What | Number |
|---|---|
| Outer size | 36 × 36 inches |
| Space between posts | about 29 × 29 inches |
| Posts | 4×4 lumber (about 3½ inches square) |
| Height | 38 inches tall — not 36. A 40 inch version can come later. |
| How they join | Magnets snap them together, then two latches per side take the load. The first latch sits 12 inches below the top (about 26 inches off the floor) — not 18. The second is Design-reserved on the same line, typically 6–8 inches above or below (exact offset draft). |
| Plywood | ½ inch for plates the X1 can cut. ¾ inch for tops and shelves that hold weight. |
| First saw | DeWalt DWS716XPS. Base about 27.2 × 22.4 inches — fits the 29 inch opening, tight front-to-back. |
| Wheels | Locking casters. Brand not picked yet. |
Still open
- Open Magnet strength and size
- Open Latch brand
- Open Caster brand
- Open How far the DWS716XPS head swings
- Draft Shopping / buy lists — not on this site
What’s next
Now
Physics-bearing 3D is live for Flat, Extension, and Miter — aprons, rails, shelf, and saw nest in place. Snap and latch faces match the Gen-0.1 freeze. Still a draft catalog, not a buy list.
Next
Pick latch and caster brands, magnet size, the second-latch offset, and measure the saw swing.
Later
Check that a real Flat rolls, docks, and does not rack itself apart. Then build one — not a store page.