Miter (DWS716XPS) · Workbench

Loading 3D…

Same Flat DNA (schematic but bearing): aprons, lower rails, a full ¾ inch shelf, and an X in the lower bay.

A ½ inch nest for a DeWalt DWS716XPS (12 inch compound — it does not slide). Rubber feet sit on that nest. About a ¾–1 inch service gap on the sides; front-to-back stays tight.

Rear keep-clear marks a dust path outside the latch strip — bag depth is still open. Fold-off stock wings are out of this Gen-0.1 picture (they stow for dock). Head upright — swing is still open.

Locked sizes

Outer size36 × 36 in

Between postsabout 29 × 29 in

Saw baseabout 27.2 × 22.4 in

Fittight front-to-back

Height38 in tall

Latches2 / side · 1st 12 in below top

Insertsremovable · later saws

Parts

—

Honest limits

The saw base fits, barely, front-to-back. How far the head swings is still open — do not assume it stays inside 29 inches. Insert sizes are a draft hint, not locked.